The ANVL Beretta 20X/30X Optic Plate is a rear dovetail style optic plate mounting system with a singular centered set screw for added mounting. This optic plate was designed for the Beretta Tomcat 30X and the Beretta Bobcat 20X. Please apply a dot of blue Loctite to the set screw upon installation. This set screw location does not specifically dictate the actual center relationship between optic plate and slide. You should still measure your left and right side distances making sure that they are equidistant to the right and left of the slide.
This optic was designed for the RMSC style optic patterned Optics. We do not have a rear set of recoil lugs so it fits a greater number of optics in the RMSC family.
We are unsure of a quality fit in older Legacy models of the Tomcat and Bobcat.
These plates are machined to a tight tolerance for the rear dovetail. Because factory slide dovetails vary within their own tolerance range, fit may feel tighter or looser from gun to gun.
All ANVL products should be installed by a professional gunsmith. ANR DESIGN is NOT responsible for poor Gunsmithing installation techniques and damage to personal property.
Casey Gibbons (verified owner) –
Recoil lugs are too tall for a holosun 407k x2. The optic had a considerable gap between it and the optics plate. Had to take a diamond file to the lugs to make them half as tall. The set screw provided could be longer as well. I emailed this company saying I’d fix it because I’m impatient. Haven’t heard back either.
Alex Costa –
We just measured them vs k size HS optics. Post on plate is .0455. Recoil lug holes on Holosun are .0475. They are purposely tight. The optics have a tiny airgap (EPS CARRY) at the rear of the optic on a flat surface. Our plate may have a tiny bit of bowing WITHIN tolerance from the fixture location and how it’s cut. The plate recoil lugs work with 5 other optics perfectly. The inner radius of the HS recoil lug could have a different radius or also be out of spec. There are a lot of factors and tolerances to account for and pins being too long just doesn’t micrometer as the issue here. The plate bow disappears as soon as the optic is torque to spec.